SV8100 with Layer_2 Errors

[quazimotto]

Guys,

Greetings! I have a an SV8100 connected to an Asterisk via PRI. The span is up but nothing will go through. When I use the SV8100 DbgTerm I see:

iUnitITSU::upUnitMessage(Slot=4) Layer 2 Error Report (27H:0BH:03H:01H:01H:0BH)
DATA[2] 22H to 27H and 81H: Clear ISDN selector

Does anyone know what this is indicating I need to change?

Thank You,
quaz

 

[CoralTech]

PRI on the 8100 needs to be set for Tie. Then you need to setup the programming for that in F-route and numbering plan. Also I assume you are using a T1 crossover cable and one is set for slave and one master.

 

[quazimotto]

CoralTech,

Thanks for the comeback. Set the card as a tie trunk not a PRI trunk?

quaz

 

[CoralTech]

Yep. I'm assuming you are trying to call to both systems.

 

[quazimotto]

CoralTech,

Yes, I am trying to tie them together. No pun intended! Could you expound on your config a little more? Did you create the dahdi.conf or did you allow the Sangoma card to create it?

Thanks,
Quaz

 

[CoralTech]

I have no idea on Asterisk programming.

 

[quazimotto]

Thank you, CoralTech. I should be able to make it work now.


Thanks again,
Quaz