SV8100 Debug Terminal - Changing Programming Data

[MysteryPhantom]

Hi, please can anybody shed some light on what commands I would need to use to change programming data using the SV8100 Debug Terminal. I am along the right lines of using PRGINFO DEBUG or would it be SYSDATA? If so where do I then go from there? Help is appreciated!

 

[belevedere]

The debug terminal is not used to program the system data. It is used for deep troubleshooting with the assistance of NEC NTAC. All programming is done using PCPRO or through a multiline telephone.

 

[MysteryPhantom]

Hi Belevedere,

Thank you for your reply. I'm attempting to modify a default setting that can't be changed in PC Pro. I'm aware of a way to do this using the debug terminal however haven't quite got there yet. It is a pretty tightly kept secret!