Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SuSE Linux Network setup on IBM PowerPC B50

Status
Not open for further replies.
skiddy

skiddy

Technical User
Aug 3, 2000
16
0
0
AU
I am trying to configure a IBM B50 PowerPC running SuSE Linux I have finally got the system to boot ok but I am having problems getting the network to run. I have allocated the IP address and also the subnet but when the system boots the screen displays "Setup Network Device eth0" then three lines are displayed "SIOCIFADDR: no such device", "SIOCIFBRDADDR: No Such Device" and "SIOCIFMASK: No Such Device". I have checked the /etc/modules.conf file and the "alias eth0 off" line exists.

If anyone has the solution to this I would be greatful fo any assistance.
 
Status
Not open for further replies.

Similar threads

thewmatz
  • Locked
  • Question
diable Line call on a NEC SV9100
Replies
0
Views
46
thewmatz
thewmatz
Rob P
  • Locked
  • Question
ISP To Switch \ Small Office Network
Replies
0
Views
51
Rob P
Rob P
Hanale
  • Locked
  • Question
Default Nortel Networks logins
Replies
0
Views
51
Hanale
Hanale
notsoevilgenius
  • Locked
  • Question
NEWBEE NETWORK SETUP
Replies
0
Views
36
notsoevilgenius
notsoevilgenius
GoranCarter
  • Locked
  • Question
Due to the fault of the ML1 Board on a PTN 950, A CES Service Was Unavailable
Replies
0
Views
36
GoranCarter
GoranCarter

Part and Inventory Search

Sponsor

Back
Top