Supress page header on last page

[Lhuffst]

In XI, how would you supress the page header on the last page? I am printing the cummulative totals on the last page and the header leaves to much white space. So I was wondering if it could be supressed? I can't minimize it because I need it for the previous pages.
thanks
lhuffst

 

[IanWaterman]

In section expert suppression enter

pagenumber = totalpagecount

Ian

 

[Lhuffst]

Thanks

 

[Lhuffst]

Can you do an uderlay section in a report footer? I placed a crosstab in the report footer and need to place a label for the row name. I was able to do this in a group header (thanks to this wonderful site) but cannot seem to get the same thing to work in a group footer.

What I need is for this crosstab and label to print only at the end of the report if the user selects Show Cummulative counts.

Thanks
lhuffst

 

[IanWaterman]

YOu can split the Report footer into two subsections and then underlay the top section.

Ian

 

[Lhuffst]

I tried that but it doesn't place the label where I need it.

I have
Report Footer A = Cross Tab
Report footer B = Label that I need to go above row values in cross tab
Report Footer C = Legend (needs to stay after cross tab)

On RFA I had underlay following section. This put the label at the bottom of the row.
Moved the RF-B TO RF-A so it looked like label, crosstab, legend. Marked underlay following sections on A and this does put the label in front of the the row column but it does a page break and then shows the cross tab.

Also, do you know how to get rid of extra white space in a page header? I did fit section but still have a lot of space between the header and the crosstab. This is only on the page header/report footer page.
Thanks

 

[IanWaterman]

If you are getting a page throw before Crosstab, it would indicate you have the cross tab formatted as keep together and it is too big for the remaining page space. So either make the cross tab smaller or uncheck keep object or section together.

To remove white space in pageheader, split PH as close to data as possible and then delete new section.

Ian

 

[Lhuffst]

That was it. Thanks so much!