Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Suppressing Blank Pages
- Thread starter Balarao
- Start date
IanWaterman
Programmer
YOu need to look at your section formatting and where and how you are using New page before/after.
Also make sure Subreports are not generating any white space at end of report as these could go onto a new page.
Under subreport formatting also uncheck keep object together as if SR is bigger than a page it will automatically open a new page too.
Ian
Also make sure Subreports are not generating any white space at end of report as these could go onto a new page.
Under subreport formatting also uncheck keep object together as if SR is bigger than a page it will automatically open a new page too.
Ian
If your Crystal is version 9 or higher, then Section Expert should include 'suppress blank section'. Put the subreport in its own section and use this. (Right-click on the section to access.)
It always helps to give your Crystal version - 8, 8.5, 9, 10, 11 or whatever. Methods sometimes change between versions, and higher versions have extra options.
![[yinyang]](/data/assets/smilies/yinyang.gif "[yinyang] [yinyang]")
Madawc Williams (East Anglia, UK). Using Windows XP & Crystal 10
It always helps to give your Crystal version - 8, 8.5, 9, 10, 11 or whatever. Methods sometimes change between versions, and higher versions have extra options.
Madawc Williams (East Anglia, UK). Using Windows XP & Crystal 10 - Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question