Hello,
I'm trying to configure a LLC-SNAP ATM PVC to a Cisco Router and not having any luck. I loaded SUNATM drivers v5.0 into the Sun, and have looked around the atmadmin tool, but I did not see anywhere I could do RFC-1483 PVC.
The SunATM documentation says it is supported but does not show examples anywhere else in the book on how to configure it. Has anyone done this type of connection before, help!
From Sun ATM v5.0 ....
Software Features
The SunATM software is compatible with relevant emerging standards (including existing ATM Forum baseline specifications and ITU-TS), and supports:
o IETF RFC 1577 for Classical IP over ATM
o IETF RFC 1483 for Protocol Encapsulation over ATM (except for bridge encapsulation) <<< Supported, no examples or config tool!
o ATM Forum recommendation for UNI 3.0, 3.1, or 4.0
o ATM Forum recommendation for LAN Emulation 1.0
Thanks
Corey Cleric
ccleric@foundrynet.com
I'm trying to configure a LLC-SNAP ATM PVC to a Cisco Router and not having any luck. I loaded SUNATM drivers v5.0 into the Sun, and have looked around the atmadmin tool, but I did not see anywhere I could do RFC-1483 PVC.
The SunATM documentation says it is supported but does not show examples anywhere else in the book on how to configure it. Has anyone done this type of connection before, help!
From Sun ATM v5.0 ....
Software Features
The SunATM software is compatible with relevant emerging standards (including existing ATM Forum baseline specifications and ITU-TS), and supports:
o IETF RFC 1577 for Classical IP over ATM
o IETF RFC 1483 for Protocol Encapsulation over ATM (except for bridge encapsulation) <<< Supported, no examples or config tool!
o ATM Forum recommendation for UNI 3.0, 3.1, or 4.0
o ATM Forum recommendation for LAN Emulation 1.0
Thanks
Corey Cleric
ccleric@foundrynet.com