Summit48i CARD_HWFAIL ...problem

[egle]

Hello,
we have the following error messages appearing Summit48i:

09/10/2003 05:22.00 <CRIT:SYST> Sys-health-check [ACTION] (PBUS checksum) (CARD_HWFAIL_PBUS_CHKSUM_EXT_ERROR) slot 1

09/10/2003 05:21.40 <CRIT:KERN> Sys-health-check [EXT] checksum error on slot 1 prev=0 cur=cdcd

Any ideas how to fix the problem?

Thanks.

 

[icvanstra]

Similar issue on my Black Diamond. I'm going throught the process of bringing the hardware up to a more current rev. Although still not 7.x.

I had to reboot my BD no long after I found the similar error and have not seen it since.

You can run the diagnostics against that blade and have it mark the memory as 'bad.' There is a limit to how many times this can occur.

I'd try the standard M$ response of: reboot...

Keep in mind when you run the diags it pretty much takes your switch offline. I found this out the hardway...