Summit 200-48 Managed Office Config

[Steve74]

I'm in need of configuring a single Summit 200-48 switch for use within a serviced office environment.

There will be one shared Internet connection which I am anticipating adding into a 'backbone' VLAN with 7 other VLANs that will be able to access the backbone VLAN but not each other.

The problem is I cannot figure a way to prevent traffic each of the client VLANs entering each other client VLAN

I have tried using access-lists, access-profiles, RIP and OSPF (which is not available with my Edge licence) but to no avail.

Any ideas?

 

[SaleenSolutions]

We have this setup on a bit bigger scale. My words of advice, saetup the WiFi via a VLAN and if you're using VoIP remember to setup QOS. If you're using Altitude 300's as your APs then make sure you have PoE setup on a few of your Summit Ports. Other than that, the installtion instructions should be able to guide youthe rest of the way.

 

[Steve74]

Thanks for the reply, however this particular setup requires wired connections. I have since discovered I could achieve my goal by creating Access lists to specifically block the IP subnet for each clients VLAN to the others. This resulted in quite a few access lists and seems a bit long-winded and messy, but has achieved the desired result.