Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
subnet change
- Thread starter harpal
- Start date
MoshiachNow
IS-IT--Management
way1: re-run "smit mktcpip" and fill the correct values.
way2: command line
chdev -l en0 -a netmask="255.255.0.0"
then check routing table (netstat -rn) and correct it if needed.
You can flush the routing table (route -fn) then rebuild it using cfgmgr (after that check default route).
Both ways use local console or any other network interface for your tty, as the connection might hang.
No reboot will be needed in any ways.
--Trifo
way2: command line
chdev -l en0 -a netmask="255.255.0.0"
then check routing table (netstat -rn) and correct it if needed.
You can flush the routing table (route -fn) then rebuild it using cfgmgr (after that check default route).
Both ways use local console or any other network interface for your tty, as the connection might hang.
No reboot will be needed in any ways.
--Trifo
- Thread starter
- #4
- Status
