I want to config an ethernet subinterface (e0.1) that is on the SAME subnet as the actual ethernet interface (e0)
What do I need to specify in the router that would allow me to bind an IP address to a subinterface so I can specify routes using this new virtual interface?
Right now it is telling me I cannot route until the subinterface is designated IE802.0 or vLAN
Any help is appreciated as always
Matt
What do I need to specify in the router that would allow me to bind an IP address to a subinterface so I can specify routes using this new virtual interface?
Right now it is telling me I cannot route until the subinterface is designated IE802.0 or vLAN
Any help is appreciated as always
Matt