Sub menus on FLashtalk2

[thebiggerhalf]

On a flashtalk2 rev. 2.0.1, I set up path 0 with path 1 as a sub menu.
When I try to program path 1 1 it offers "menu" on the left hand soft button, but when I press it, it says "no path available". Would Nortel really offer an option button for an option that is not available?

 

[norstarboy125]

you need to disable the ccr before you make chgs...if you set up path 1 as a menu then by all means you should be able to set up path 1 1 as your sub menu.

 

[thebiggerhalf]

This was a new CCR (tree 2). Everything else I programmed on tne tree, (ie. path 2, 3 etc) worked fine. It just wouldn't let me do a path 1 menu from path 1.
PATH 0: for admin press 1
PATH 1: for accounting press 1. This is the point that the softkey offers a menu button but then says no path available. I want to complete the next step below.
PATH 1 1: for MAry press 1, Joyce press 2.

 

[cook1082]

Path zero is the home menu node. In the greeting you say press one for admin and that is path 1(press one).path 2 would be accounting then 1 1 , 1 2.

 

[hawks]

I think with the Flash you could only go 2 levels. So if that's the case then 1 1 could not be a Menu because you can not finish a Tree with a Menu choice.

 

[JBinSanD]

cook has it right.
Path zero will Always be a Menu Path. If you want more options under path 2, you must make path 2 a menu path also, record Accounting options and add them(ie 21, 22, 23 ect)