Straight T1 setup 1

[PhoneTechMan]

Hello to all, does anyone happen to have a cheat sheet on the setup of a straight T1? I found a link to a previous thread, but the post has since been removed. Thanks In Advance.

Tony

 

[killbox]

Lines/Trunks -> LS/GS/DS1 -> Slot #

Type: T1
Signaling: (Signaling type)
Suppression: (Suppression)

Go back into Type, T1 -> Enter and the screen will change.
Select all tie and enter trunks.

Add trunks to your pool

KILLBOX

 

[PhoneTechMan]

Thanks, that's exactly what I needed, worked like a charm.

 

[killbox]

Not a problem

KILLBOX

 

[franke]

The line type depends on what you ordered from your vendor and could be all loopstart, ground start, DID, TIE or a combination of any or all types, just make sure you assign the correct type to the corresponding channel(s)

franke

 

[killbox]

Right. Well, groung and loop is for ground or loop start pots line. When ever you're doing a plain T1, you can just do all Tie if it's all 24 channels, or just select tie and select the channels that are being used.

KILLBOX