Hi,
I hope someone has an idea of how to resolve the issue with the TL891 autoloader that appears to have been configured for slave mode. Every time I start the unit, I receive Fault Code 300F | Slave Init Error | Enter to Reboot or | Power Down to Clear.
When I try to go to the Configure Menu to set the device as Standalone, it reboots on hitting the Enter button - and returns to the same error. Powering down has the same effect.
Is there any way to hard reset the TL891 back to factory defaults so I can bring it up as a standalone unit?
Thank you
I hope someone has an idea of how to resolve the issue with the TL891 autoloader that appears to have been configured for slave mode. Every time I start the unit, I receive Fault Code 300F | Slave Init Error | Enter to Reboot or | Power Down to Clear.
When I try to go to the Configure Menu to set the device as Standalone, it reboots on hitting the Enter button - and returns to the same error. Powering down has the same effect.
Is there any way to hard reset the TL891 back to factory defaults so I can bring it up as a standalone unit?
Thank you