brewerdude
IS-IT--Management
How do you get Procomm to not run the last script you ran when selecting a site? I've been through all the program options and can't figure out where to do this.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Stopping script on startup 1
- Thread starter brewerdude
- Start date
- Status
-
1
- #2
Try looking at the settings for that entry in the Connection Directory and see if there is a script associated with it (you'll need to click the Basic Options button to see this information).
aspect@aspectscripting.com
aspect@aspectscripting.com
- Thread starter
- #3
- Thread starter
- #4
brewerdude
IS-IT--Management
Shoot! I went back into Procomm this morning and opened up my telnet site, and it ran the last script I ran last night. When I went to the connection directory, that script was there in the startup.
Are you recording a script by chance? If so, it will get attached to the Connection Directory entry unless you check a box in the dialog.
aspect@aspectscripting.com
aspect@aspectscripting.com
- Status
Similar threads
- Locked
- Question
