I have been having an issue when creating a new map. On the outbound side when I edit the properties under the delimeter tab I have element delimeter set to an "|" (pipe).
I also check the box that states always output trailing element delimeter for elements with data. However when I run my data I notice not all the records that I create have the "|" at the end. I have corrected this by adding an extra output field for the pipe but I am affraid this is going to cause issues down the road. Has anyone else ran into this problem or know how to correct?
I also check the box that states always output trailing element delimeter for elements with data. However when I run my data I notice not all the records that I create have the "|" at the end. I have corrected this by adding an extra output field for the pipe but I am affraid this is going to cause issues down the road. Has anyone else ran into this problem or know how to correct?