jims5650
MIS
- Dec 12, 2005
- 11
- 0
- 0
Are there any utilities for an IP office 403 to status the voice channels and D channel?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Status voice channels
- Thread starter jims5650
- Start date
- Status
victor5908
Programmer
It's not much,but open monitor,click on status and choose PRI option.
Check out Monitor doc's in toolkit-maybe you can manipulate to see what you want.
It basically just shows in service/out of service.
It is real time and will show you when th LEC brings the circuit up.
Check out Monitor doc's in toolkit-maybe you can manipulate to see what you want.
It basically just shows in service/out of service.
It is real time and will show you when th LEC brings the circuit up.
SuperJenks
Vendor
Yes, call status (probably your best bet), and monitor if you can make any sense of the data (Not practical). Also ccc will do this for you the best, but very expesive for what you want to do. You might be able to assign channels to buttons as direct line appearances. This would give you a blf indicator to tell what channels are in use.
- Status
