chrisvincent
Technical User
I am currently configuring stateful failover on a pair of PIX-515e.
I have configured failover before on these boxes without problems, however I am getting a cable status of "other side powered off" on the primary.
I have done everything obvious i.e. made sure both are on correct versions, checked the failover cable and even swapped out the failover pix etc etc....all the pre-requisites detailed in the cisco docs regarding failover.
I can see on the arp table of the primary all the interfaces on the failover.
Anyone know of any reasons why the cable status will not change to normal?
I have configured failover before on these boxes without problems, however I am getting a cable status of "other side powered off" on the primary.
I have done everything obvious i.e. made sure both are on correct versions, checked the failover cable and even swapped out the failover pix etc etc....all the pre-requisites detailed in the cisco docs regarding failover.
I can see on the arp table of the primary all the interfaces on the failover.
Anyone know of any reasons why the cable status will not change to normal?