On a Meridian 61C, how do you STAT an extension? I can STAT a loop or the system, but not a single extention (eg DN 4132). Thanks in advance for any help.
To stat a line, you'll need it's tn number. You can get that in ld 20. You can stat the tn in ld 32, and also in ld 20 at the REQ prompt unless your software revision is very old.
Hi
go into LD80
then
(enter) trac 0 xxxx where xxxx is your extn number.
you will then get IDLE and the TN
if you lift the handset and repeat the TRAC you will get more.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.