Hi everyone. I was wondering if anyone can help out on a vm issue. I've installed an inskin HDD VM card into an STS system...was wondering how i can get program it via laptop. Do i require any special software? I tried to go through hyper terminal (STS program manual has instructions how to do it) but with no results. The main screen in hyper terminal is blank and even though i type '0000' nothing happens.
Also, if i wanted to program it through the pbx system, i could, couldn't i? any advice and suggestions are very much appreciated, thanks!
Also, if i wanted to program it through the pbx system, i could, couldn't i? any advice and suggestions are very much appreciated, thanks!