I need to take a startalk flash from 1.5 to 1.9 software. What is the best way to do so and has anyone been successful without losing the programming in it.
Thanks, I am eager to know, what everyone has found out with this.
Power down, swap the software, power on and give it about 5 minutes to bootup. Then dial F903 and accept the feature code range F980-989. Dial F983, enter 266344, then just press Y or OK at the next few screens. When you're done your programming should still be there, but your mileage may vary. Good luck!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.