Hi,
I am having a problem where i am trying to do something very simple (or so it would seem!!)
I have two Linksys switches:
SRW224G4P running version 1.3.1 (latest i believe)
SPS2024 running version 1.0.2 (again latest i believe)
What i am trying to do is uplink the 2 switches so that i can talk/send packets between each other, one has an IP Address of 192.168.1.251 and the other has 192.168.1.252 but i cannot ping between them.
The switches have a completly flat config with only the default vlan and IP Addresses configured.
I can give my laptop a static address in the same range and plug into each switch and ping the ip address ok.
Is there any additon setup required as i believe that this scenairo should work ok.
Any thoughts would be much appreciated.
Thnaks.
I am having a problem where i am trying to do something very simple (or so it would seem!!)
I have two Linksys switches:
SRW224G4P running version 1.3.1 (latest i believe)
SPS2024 running version 1.0.2 (again latest i believe)
What i am trying to do is uplink the 2 switches so that i can talk/send packets between each other, one has an IP Address of 192.168.1.251 and the other has 192.168.1.252 but i cannot ping between them.
The switches have a completly flat config with only the default vlan and IP Addresses configured.
I can give my laptop a static address in the same range and plug into each switch and ping the ip address ok.
Is there any additon setup required as i believe that this scenairo should work ok.
Any thoughts would be much appreciated.
Thnaks.