SRG 200 new firmware

[hemsanda22]

Hi all,
I have one SRG 200 Rls 4.0 with 20 IP phones.I need to upload new firmware to IP phones (064C6R) I uploaded latest patch to system, BCM[1].R400.SU.System.023-200909-1.0-1.0 but still phones showing 064C1B.
So Is there a any way to upload firmware to IP phones.

Thanks
Aruna

 

[biv343]

Once the phones are redirected to the main office, you can issue the umsUpgradeAll command on the main office signaling server. That will push out the firmware that is on the main office to the sets registered to the SRG.

 

[gwebster]

..which assumes that you have loaded C6R on the main office to start with.

 

[hemsanda22]

Thanks Guys,

Main office already loaded on C6R.And I have several SRG 50 rls 3.0 also connected. Once uploaded the latest patches all phones getting C6R on SRGs.
Thats why I want to know because If we push out the firmware from main office we need very good bandwith.
Am I correct?

 

[biv343]

Thanks gwebster. I forgot to mention that. Gotta remember to never assume.

If bandwidth is an issue, you can schedule the download by specifying an hour/minute after the umsUpgradeAll command. For example, umsUpgradeAll 02:00 will start the upgrade at 2 AM.

I've pushed it out to 20 or so sets over a T-1, and they all complete in roughly 10 minutes. The files aren't that terribly huge.

 

[hemsanda22]

Thanks a lot biv343.
Can you please briefly explain how to use umsUpgradeAll command?

 

[gwebster]

hemsanda22.
Go to

http://www.nortel.com/cs1000

-> "Technical Documentation" and download a copy of "Main Office "Configuration Guide for SRG 50". Then look at the "Enhanced UNIStim Firmware Download" section for information on the umsUpgradeAll command.

 

[Dasheen]

FYI
If u have more than one sig svr in your network, u'll have to issue the ums command from all sigSvrs.