Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SPU4

Status
Not open for further replies.

rfpup

Technical User
Dec 1, 2004
334
US
Hi to all,

I tried to update the software revision of the SPU4 from R5B to R6A using CNBLI, CNBSI commands.
Yesterday the situation was:
001-1-20 SPU4 ROF1375430/1 R2A
CAA 158 0023 R6A EXET
but today after CNBIP command I see the following:

001-2-20 SPU4 ROF1375430/1 R2A
CAA 112 2909 R3A PAS
Any idea?

Thank you
 
the first printout is from card 1-1-20, the second printout is from 1-2-20. That`s the problem...
 
Hi,

Position could be one reason but also make sure CNBCI command is sent .... This is to confirm Firmware upgrade...

Cheers

""The truth about action must be known and the truth of inaction also must be known; even so the truth about prohibited action must be known. For mysterious are the ways of action""
 
thanks to all,

The system accepted the command cnbci when free from IP networking.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top