SPM remote barrier code issue 1

[techguru69]

I've assigned a CO line for remote access via Winspm. It's plugged into 805. I can dial it and attach to the modem no problem (all barrier codes were removed by a vendor when troubleshooting the ARS and where never put back). But, I want a barrier code assigned to it for security and not any other of the lines. How do I accomplish this?

Thanks.

 

[bsabb]

To set up a barrier code:
winSPM
Sys program>start
Lines/Trunks>remote access

under linestrunks make it dedicated
under nonTIE make barrier code required
set the restriction to outward restrict
set ars restrict to 3

Do the same for TIE lines

under Barrier Code
sprog/maint - 1
code info - set code length to 7
code entry - whatever 7 digits you choose
restriction - outward restrict
ARS restrict - 3

This will keep anyone from using the DISA to call outside of the switch and allow you to dial in. Do not forget when you call in over the DISA line to wait for the stutter tone, enter the barrier code, get return dial tone and enter *10. You will here the modem connect.

Hope this helps