I am tring to split a exp300 backplain in to two so that two servers can share it at the same time. does anyone know how this is done or have some place I can find it at?
The information you seek is contained in the EXP 300 Installation & Users Guide on page 13. Disconnect power from the unit, remove the Switch card (from the rear, in the center of the unit). On the left side of the switch card, there are 4 internal switches. Switch 3 controls the SCSI bus. Turn it "on", re-install the switch unit, apply power and you're done!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.