Is there something you can set up in the Sonicwall so that it can allow a range of IP addresses to not get their connections dropped?
Here's the messages I get from Control Scan...
Information From Target:
Port 443 was detected as being open but is now unresponsive
Connections to this host from the scanner with IP address 69.16.180.6 were blocked on 2010-09-04 11:40:43 (GMT).
Solution:
1.Use a slower scan speed setting.
2.Disable your IPS during the scan.
3.Review packet filters on target.
Details:
One of several ports that were previously open are now closed or unresponsive. There are numerous possible causes for this failure:
Here's the messages I get from Control Scan...
Information From Target:
Port 443 was detected as being open but is now unresponsive
Connections to this host from the scanner with IP address 69.16.180.6 were blocked on 2010-09-04 11:40:43 (GMT).
Solution:
1.Use a slower scan speed setting.
2.Disable your IPS during the scan.
3.Review packet filters on target.
Details:
One of several ports that were previously open are now closed or unresponsive. There are numerous possible causes for this failure: