One of our servers was recently provisioned with 88 luns. This is on SRDF - R1/R2.
The R1 side is fine I can see both paths in powerpath for all luns.
On the R2 side some luns (around 36) show single paths. Solaris (format) shows both paths.
These are the commands I tried -
powercf -q
powermt -config
powermt -save
powermt -check
devfsadm -C -c disk
I also tried -
luxadm -e forcelip /dev/cfg/cx
Besides a reconfig reboot anything else I can try ?
The R1 side is fine I can see both paths in powerpath for all luns.
On the R2 side some luns (around 36) show single paths. Solaris (format) shows both paths.
These are the commands I tried -
powercf -q
powermt -config
powermt -save
powermt -check
devfsadm -C -c disk
I also tried -
luxadm -e forcelip /dev/cfg/cx
Besides a reconfig reboot anything else I can try ?