I have two questions:
1) How can I edit custom properties in SW2004 through a VB APP?
2) How can I open a new part, create a sketch & then extrude a sheet metal flange through VB? Just a small example... say one 5 inch line starting at origin 0,0,0 & ending at 0,0,5 & then a flange extruded to a height of 5 inches w/ a thickness of 0.0625 inches?
Any help would be greatly appreciated.
Thank you in advance.
1) How can I edit custom properties in SW2004 through a VB APP?
2) How can I open a new part, create a sketch & then extrude a sheet metal flange through VB? Just a small example... say one 5 inch line starting at origin 0,0,0 & ending at 0,0,5 & then a flange extruded to a height of 5 inches w/ a thickness of 0.0625 inches?
Any help would be greatly appreciated.
Thank you in advance.