Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Softswitch and Nortel's Communication Control Toolkit

Status
Not open for further replies.

jensjuul

Programmer
Jul 28, 2007
50
DK
Hi,

I am thinking of writing a simple softswitch for the Nortel CS 1000 system and I was just wondering whether or not I would be able to use the Communication Control Toolkit from Nortel?

As far as I can read in the technical information I am able to control the flow of a call. Is that right? If a person calls I will be able to answer, transfer and end this call?

Do you know if it is possible to create a busy lamp view using the Communication Control Toolkit and TAPI?

Thank you so much!!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top