Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SNMP Value for Cisco R3640
- Thread starter sniffi
- Start date
vlad
+---------------------------+
|#include<disclaimer.h> |
+---------------------------+
+---------------------------+
|#include<disclaimer.h> |
+---------------------------+
- Thread starter
- #3
Unfortunately "channels" could mean a lot of things. Do you mean channels for PRI ISDN being used for Remote Access, or channels used for voice calls on Voice Trunk.
You need to narrow down the particular subsystem you want to look at. I then do a "grep" of the MIBs available (either from the vendor or preferrably from IETF or other standards) and then monitor the variable.
In your case if use a "channel" and you are monitoring the right variable/table you should see the variable change.
You need to narrow down the particular subsystem you want to look at. I then do a "grep" of the MIBs available (either from the vendor or preferrably from IETF or other standards) and then monitor the variable.
In your case if use a "channel" and you are monitoring the right variable/table you should see the variable change.
- Status
Similar threads
- Locked
- Question
- Locked
- Question