Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SNMP trap destination for CUCM6

Status
Not open for further replies.
eksantrik

eksantrik

Technical User
Dec 13, 2005
74
US
I have been working with CUCM6 for a while now. I would like to configure the box to send all possible SNMP traps to a single destination.
As far as I know, I you need to go under serviceability and set the snmp trap destination for diffrent services. Is there a quicker way to configure the system to send any possible traps/debugs (anything) for every service and event to a single destination?

Thanks
 
Status
Not open for further replies.

Similar threads

smrikard
  • Locked
  • Question
Need Unity OVA install file for ISR 4331
Replies
1
Views
265
smrikard
smrikard
mikedphones
  • Locked
  • Question
MASS - Looking for a Cisco Call Manager support tech to move and reconfigure
Replies
0
Views
256
mikedphones
mikedphones
jarod_paris
  • Locked
  • Question
firmware for an AP2800 WiFi terminal
Replies
0
Views
139
jarod_paris
jarod_paris
bobo0605
  • Locked
  • Question
Cisco Call Handler for After Hours
Replies
4
Views
220
reztek
reztek
Qzwsa
  • Locked
  • Question
Inband DTMF to SIP device for zone paging
Replies
1
Views
128
LoPath
LoPath

Part and Inventory Search

Sponsor

Back
Top