Smit: programming tools

[Moose467]

Hi to all,
I have problem on a few servers (H80, H50)
I want to change a setting on a printer to stop printing out a blank page after each print.
I used to be able to go into smit printers, then print Spooling, then programming tools, now whenever I go into change/show printer attribute database it falls over, either with a segmentation fault(coredump) or a IOT/Abort trap(coredump).
Does any body know what is happening?
do I have to many printers configured on my system?
Thanks for any help you can give

Phil

 

[jprabaker]

I would suggest you start by looking at the revision level of the print fileset ( I think its bos.printers.rte..)and check it against the version available from the IBM fixes database - if their is a newer version install that.