Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SMDR5 2

Status
Not open for further replies.
OMBD

OMBD

Vendor
May 24, 2002
74
US
Attached SMDR5 to DN port and then to 7310, serial port to COM 1, Software on PC loaded, shows collection started and processing started but no call records. Is any programming required for this DN to handle SMDR? Thanks.
 
Sort by date Sort by votes
To access programming on the SMDR unit dial Feature 9*2 from any 7310 or 7324 phone on the system. Then scroll through the parameters and change to your requirements. Brian Cox
J & J Communications
brian@jandjcommunications.com
 
Upvote 0 Downvote
Thanks Brian, I will be on site next week and try this procedure. Any certain baud rate or parameters work best for the SMDR5? Thanks in advance.
 
Upvote 0 Downvote
Most SMDR outputs are 1200 baud, 8 data, 1 stop, no parity. I think this is where the SMDR unit is set by default. You will want to check the call format and types of calls that will be output. Brian Cox
J & J Communications
brian@jandjcommunications.com
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

MamaSig
  • Locked
  • Question
SMDR5 used on MICS installation
Replies
3
Views
57
exsmogger
exsmogger
MontrealSoft
  • Locked
  • Question
SMDR5 and SMDR6 differences ?
Replies
0
Views
21
MontrealSoft
MontrealSoft
MontrealSoft
  • Locked
  • Question
Dead SMDR5... Asking for a firmware !
Replies
0
Views
21
MontrealSoft
MontrealSoft
DRTDVL
  • Locked
  • Question
Nortel 8x24 SMDR5 installation
Replies
1
Views
35
stefanog65
stefanog65

Part and Inventory Search

Sponsor

Back
Top