SMDR NEAX 2000 IPS

[mitchell70]

I have a 2000 IPS migration from a IVS. It is using the CP 26 CPU. The onboard SMDR on RS1 of the MP stopped working (RS0 is being used for MCI for IM16 VM) and can no longer output. Tried everything to get that to work except a replacement. Found out that the IPS can SMDR via IP and have everything set per the manual but still get no output. Tried hyper terminal to verify and get no data. The only programs I am unsure about is the CMD OB00 and the CMD OB02. I am able to ping the IP address of the CPU and have remote access but cannot get any records to output even as raw data. The SMDR was working before so mostly all the data still is the same. What am I missing?

 

[belevedere]

The Ap-oo card needs to be a PN-AP00-B/PN-AP00-D card. The old one will not work.
The attached manual may help.

 

[mitchell70]

Thanks for the response, however the AP00-B has been replaced and there is still no output. I even went as far as to try a third one just to be sure that is was not a faulty card. 3 different AP00-B all showing the same results. Any other Ideas?

 

[OzzieGeorge]

Why are you trying to output the data from the CPU when the AP card has four RS232 outputs on it? You can't just swap an AP00 card and expect it to work, it has to be reprogrammed virtually from scratch when replaced. See here for a cheat sheet......

https://www.australiancommsforum.com/post/ap00-programming-cheat-sheet-7542614?pid=1288273385