Theoneandonly
IS-IT--Management
Hi all,
I'm a newbie to smartstart install and I'm trying to install array config utility on an ML370T03, with ultra 3 2-channels 64-bits controller and 2*36 GB disks. I have to make a manual install due to OS requirement, but once system partition is installed, I'm unable to launch Array utility to set partitions. I'm trying to make disk support for array but it can't boot on it.
Any idea or tutorial somewhere to learn ?
Thanks
I'm a newbie to smartstart install and I'm trying to install array config utility on an ML370T03, with ultra 3 2-channels 64-bits controller and 2*36 GB disks. I have to make a manual install due to OS requirement, but once system partition is installed, I'm unable to launch Array utility to set partitions. I'm trying to make disk support for array but it can't boot on it.
Any idea or tutorial somewhere to learn ?
Thanks