Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Slow administrative shares

Status
Not open for further replies.

dslam24

IS-IT--Management
Jun 24, 2003
21
US
I have a very odd problem. There is an administrative share that I need to access.

\\server\share$

When I go to start> Run and type in the share, it takes about 35 seconds to open. It has been doing this for a long time over a year, it doesnt happen on every machine, only a few, Vista SP1 and XP SP3.

Just recently I discovered that if I open up File explorer and try to access the share from there, it opens immediately.

I've done some traffic captures to see what's going on when it's taking for ever, here is the two errors I get.
I think the first one is fairly normal.
SMB Trans2 Response, GET_DFS_REFERRAL, Error: STATUS_NO_SUCH_DEVICE

I think this one is the problem, however the share is there, it opens it after a bit.
SMB Tree Connect AndX Response, Error: STATUS_BAD_NETWORK_NAME

It disconnects about 15 seconds into the request, and then it tries again at about another 15 seconds, then the folders open up.

Any Ideas?


 
Not much on Google about that error message, one or two there mention Samba, Do you have that at your office?

Do you see the same hang if you try connecting one of the machines while it is loaded in "Safe Mode with Networking"?

If not, then check if anything else is slowing it down.

310560 - How to Troubleshoot By Using the Msconfig Utility in Windows XP

How to troubleshoot a problem by performing a clean boot in Windows Vista
 
When I go to start> Run and type in the share, it takes about 35 seconds to open.
what happens when you create a LINK to the share?

or try this:

Create a shortcut to explorer.exe and pass the UNC name of the resource.
explorer /e, \\Server\FileShare

how about mapping the share instead?

it could be the Link-Layer Topology Discovery Responder that is causing havoc there. It tends not to play well with older network equipment...

also I found that IPv6 gets in the way of things, so uninstalling it from the properties of the NICs in question (XP only, VISTA read below)...

have a peek:

Enable or Disable the LLTD Responder by Using Group Policy

Slow network performance when you open a file that is located in a shared folder on a remote network computer

Disable IPv6 on Windows vista


Ben

"If it works don't fix it! If it doesn't use a sledgehammer..."

How to ask a question, when posting them to a professional forum.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top