SLIPD errors

[motox2]

would SLIPD errors be indicative of a bad CC controller daughter board card on a PRI? i am constanly showing an increase in SLIPD errors when i run .LCNT command in LD60. i trid switching clocks to the secondary clock as referenced in DDB, but made no difference (TRCK SCLK x). any advise? thx

 

[bhassell2000]

it could be a bad CC but I would probably lean towards telco if thats where you are getting your clocking. What kind of system is it?

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[motox2]

its an opt 11. i went ahead and swapped out the PRI and im still getting SPIPD errors about 1 every 10 or 15 seconds.

 

[janaya]

open a ticket with the LEC. Have them check the circuit.

 

[motox2]

Thanks for the help, i noticed my sec ref clock under LD73 was set to the wrong card on my opt 11. i just simply set my sec ref to my PRI on slot 5, and VIOLA!! no more SLIPD errors. thanks to all