Hi, we usually use the Port 2B on the HBC card to load code. ACSLS also uses Port 2B - we must unplug the ACSLS server cable to load the code. Can the Port 2A also be used to load the code? The current code is 3.77, needs to be upgraded to 3.98b - 4.14...please advice. Thank you.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SL8500 loading of code
- Thread starter TechyG
- Start date
The 2A port on HBC is used for dual TCPIP configuration from 3.08 code.
If you dont use this port por network, you can connect your laptom for connect to HBC, (if the port was network configured).
I think that it work well...But, why you don´t stop ACSLS for this library for upgrade it firmware?, (the processs use only 30 minutes...).
Good luck!!
If you dont use this port por network, you can connect your laptom for connect to HBC, (if the port was network configured).
I think that it work well...But, why you don´t stop ACSLS for this library for upgrade it firmware?, (the processs use only 30 minutes...).
Good luck!!
- Thread starter
- #3
- Status