Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SL1100 Remote dial up modem connection 2
- Thread starter mak12321
- Start date
-
2
- #2
belevedere
Instructor
Set up from PCPro manual.
Create SL1100 Dial Up Connection
When connecting an SL1100 via modem, a Dial Up Connection
(PPP) must be created. The following steps describe how to set up
the Dial Up Connection (PPP).
1. Click Start >Settings>Network Connections.
2. Select Create a New Connection.
3. Click Next.
4. Select Connect to the network at my workplace, then click
Next.
5. Select Dial-up connection, then click Next.
6. Enter a name to be used for the dial-up connection.
7. Enter the telephone number to be dialed, then click Next.
Ensure the SL1100 programs 11-15-14, 22-02 and 22-07 are setup to
receive calls to the modem
8. Setup the availability of the connection, then click Next.
9. Click Finish.
Login
Specify the User Name and Password that will allow the connection.
The account must exist within the chassis settings 90-02. Like PCPro
Accounts, Login Accounts govern what system data can be accessed from the chassis.
It is important to note, Login Accounts are not the same as PCPro
Accounts. Thus both chassis Login and PCPro Account settings are NOT synchronized and are independent of each other.
Once connected, the PCPro access level changes to match the level assigned to the user name/password used to connect. This access level is set in 90-02 on the chassis. For example, if you start PCPro
in Installer (IN) mode, but connect to a chassis using an account with an access level of System Administrator Level 1 (SA), after connecting PCPro assumes the access level of SA. Once you are disconnected, PCPro reverts back to the access level IN.
Create SL1100 Dial Up Connection
When connecting an SL1100 via modem, a Dial Up Connection
(PPP) must be created. The following steps describe how to set up
the Dial Up Connection (PPP).
1. Click Start >Settings>Network Connections.
2. Select Create a New Connection.
3. Click Next.
4. Select Connect to the network at my workplace, then click
Next.
5. Select Dial-up connection, then click Next.
6. Enter a name to be used for the dial-up connection.
7. Enter the telephone number to be dialed, then click Next.
Ensure the SL1100 programs 11-15-14, 22-02 and 22-07 are setup to
receive calls to the modem
8. Setup the availability of the connection, then click Next.
9. Click Finish.
Login
Specify the User Name and Password that will allow the connection.
The account must exist within the chassis settings 90-02. Like PCPro
Accounts, Login Accounts govern what system data can be accessed from the chassis.
It is important to note, Login Accounts are not the same as PCPro
Accounts. Thus both chassis Login and PCPro Account settings are NOT synchronized and are independent of each other.
Once connected, the PCPro access level changes to match the level assigned to the user name/password used to connect. This access level is set in 90-02 on the chassis. For example, if you start PCPro
in Installer (IN) mode, but connect to a chassis using an account with an access level of System Administrator Level 1 (SA), after connecting PCPro assumes the access level of SA. Once you are disconnected, PCPro reverts back to the access level IN.
- Thread starter
- #3
- Status