SIP3 user

[lapakhora]

Hi all, it is CS1k rls 7.6 with third party Sip line (SIP3) = 10. CS1K is connected with an IPO using session manager.
I am trying to create a third party SIP user in CS1K. When i follow NTP and create SIPL line/Route/AML and then TN=252 0 0 0 iget error and it says MOBX user licenses are exhausted or not available.
How can i create a 3rd party SIP user (SIP3) in CS1k and get it register into CS1K.

DES SIPL
TN X X X X VIRTUAL
TYPE UEXT
CDEN 8D
CTYP XDLC
CUST 0
UXTY SIPL

 

[scotthdiv]

Shouldn't "SIP3" be used at the UXTY prompt?

 

[lapakhora]

if i put SIP3 at UXTY then it dont prompt me for any zone or dchannel.

 

[goddajoe]

Hi,

Not sure if you got this sorted. When I create SIP3 users it's important to have all the below prompts set exactly so. Otherwise I get the type of error you specified.

TYPE UEXT
CDEN 8D
CTYP XDLC
CUST 0
UXTY SIPL
MCCL YES
SIPN 0
SIP3 1

 

[lapakhora]

Goddajoe thanks for the update , i was not able to resolve till today..Let me check with your advise. It is a remote site, i will update once i get there.