SIP Trunking

[CTCINY]

Has anyone had any success installing SIP trunks on a BCM 400 R4.0? Customer just added a test trunk to there system before they switch over but I cant seem to get them up and running. I installed the keycode and rebooted the system and they have active SIP trunks so that is OK. They gave me passwords and user names but I dont even see a section where I can enter them. Any insight?

What doesn't kill you only makes you stronger.

If it's true that our species is alone in the universe, then I'd have to say that the universe aimed rather low and settled for very little.---George Carlin

 

[vztech]

I have installed sip trunks on a 4.0 with MCDN to 50's hanging off it.
What do you need to know?

It's only dialtone-VZ

 

[CTCINY]

Actually these are SIP trunks to the PSTN. Basically these trunks require authentication and I do not see anywhere to enter the username, password, etc. Whenever I hit the trunks I setup, I cannot dial out and I get a busy when trying to dial in. I set them up on a SIP softphone and they worked fine so I know the problem is with my setup in the BCM

What doesn't kill you only makes you stronger.

If it's true that our species is alone in the universe, then I'd have to say that the universe aimed rather low and settled for very little.---George Carlin

 

[Deweyhumbolt]

The Euros seem to have dealt with this already. From their conversations, I don't think the BCM50 3.0 is capable yet.

Adversity is Opportunity

 

[CTCINY]

OK then. Can anyone suggest a provider that will work with the BCM line?

What doesn't kill you only makes you stronger.

If it's true that our species is alone in the universe, then I'd have to say that the universe aimed rather low and settled for very little.---George Carlin

 

[bigg3rdude24]

the BCM 400 4.0 does not support SIP authentication via username/password. the BCM 50 r3 and the BCM 450 have it. cant you just authenticate via IP instead?