I am going to be linking 2 BCM 450's together via SIP. Both systems are under the same roof so all ip config will take place on the LAN. What requirements and network set up should I recommend to the client? What ports need to be opened? What QOS settings need to be completed? Should they set up VLAN's?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SIP Trunking between two BCM 450's
- Thread starter TDSjeff
- Start date
SupportDude
Technical User
Of course you'll need SIP trunk keycodes.
You can define the QoS to meet their needs on BCM450.
Default is DSCP ... 61 if I remember correctly.
The trunks use ports in the 28xxx range.
VLAN is up to the customer, but if the BCM's are already in a VLAN its covered.
Hope this helps!
-SD-
You can define the QoS to meet their needs on BCM450.
Default is DSCP ... 61 if I remember correctly.
The trunks use ports in the 28xxx range.
VLAN is up to the customer, but if the BCM's are already in a VLAN its covered.
Hope this helps!
-SD-
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
