SIP TRUNK

[alfalfa]

I have a lab 500 with license, and using 5410 sets in my setup, my provider is cebeyond, which has given me info of their name, ???????sipconnet.cbeyond.com and i have a telenu,mber as user id, and a password,
looking at the sip trunk form, i do not have an address to put in the itsp address field, only ?????sipconnect.
this sip trunk works fine on a cisco switch from ur data side, trying to get it to work with the ipo. using the lan 2 port on the 500,
Lan one is 192.168.42.1, lan 2 is 192.168.43.1
need to know if i need certain routes built to access the sip trunk also what should i turn on on the sip trunk page, and uri page do i use it at all. Trying out new tech.

 

[IPOfficeIreland]

have a look here

http://www.iporesource.com/

 

[IPOfficeIreland]

in the sip trunk you enter the itsp name and ip address just below or enter the ip address into both.

the user@whatever.com is set in your outbound dial rules

user"@whatever.com" as in the docs above.

have a read of them and post any problems you have. it is quite easy but there are a few settings to consider.

 

[Bas1234]

Or this link.

http://www.avaya.com/master-usa/en-us/resource/assets/applicationnotes/ses-ipo.pdf

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________

 

[Bas1234]

Not all setting in that link are good but it could help you on the right way....

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________