Sip Trunk setup

[nortelnew]

Could someone give me a step by step guide on how to set up a SIP truhk on a CS1000 to another site. And tell me what are the implications for example do i need to buy licenses etc.

 

[allenmac]

You must have SIP licenses before you do anything else.

Go to ld 22 and type SLT <return>

>ld 22
PT2000 

REQ  slt
ANALOGUE TELEPHONES       16    LEFT     2    USED    14
CLASS TELEPHONES           0    LEFT     0    USED     0
DIGITAL TELEPHONES         0    LEFT     0    USED     0
DECT USERS                 0    LEFT     0    USED     0
IP USERS                 328    LEFT   147    USED   181
BASIC IP USERS            12    LEFT    12    USED     0
TEMPORARY IP USERS         0    LEFT     0    USED     0
DECT VISITOR USER          0    LEFT     0    USED     0
ACD AGENTS                10    LEFT    10    USED     0

PCA                        0    LEFT     0    USED     0
ITG ISDN TRUNKS            0    LEFT     0    USED     0
H.323 ACCESS PORTS        96    LEFT     0    USED    96
AST                        1    LEFT     0    USED     1
SIP CONVERGED DESKTOPS     0    LEFT     0    USED     0
SIP CTI TR87               0    LEFT     0    USED     0
SIP ACCESS PORTS         100    LEFT    68    USED    32  <----- **** These are your SIP trunk licenses
RAN CON                    0    LEFT     0    USED     0
MUS CON                    0    LEFT     0    USED     0

TNS                    32760    LEFT 31815    USED   945
ACDN                   24000    LEFT 23992    USED     8
AML                       16    LEFT    15    USED     1
IDLE_SET_DISPLAY My Company Name
LTID                   32760    LEFT 32760    USED     0
RAN RTE                  512    LEFT   512    USED     0
ATTENDANT CONSOLES     32760    LEFT 32760    USED     0
BRI DSL                10000    LEFT 10000    USED     0
DATA PORTS             32760    LEFT 32760    USED     0
PHANTOM PORTS          32760    LEFT 32609    USED   151
TRADITIONAL TRUNKS     32760    LEFT 32737    USED    23
DCH                      255    LEFT   253    USED     2

If you don't have any SIP licenses, then there is no use continuing.

 

[nortelnew]

Hi ,

I have checked and i have 58 Sip licenses

whats next buddy.

 

[Reusser]

Find the NTP book IP Peer Networking - 553-3001-213

there are lists of procedures and examples for SIP peer networking.

 

[allenmac]

Here's what your going to need:

SIP Licences at each site
Signaling Servers at each site
DSP Resources at each site (VGMC, SMC32, or DSP Daughterboard on MGC)

Here's a general overview of the configuration. The IP Peer Networking book has procedures, and explains in more detail (The following steps do not necessarily need to done in this order).

1. Configure NRS on one of your Signaling Servers.
2. Build Endpoints in NRS for each location you want to network with SIP.
3. Add Routing Entries to each Endpoint.
4. Configure SIP endpoints on Signaling Servers at each site.
5. Build SIP route at each site - this includes the D-Channel.
6. Verify that your Endpoints are registered in NRS.
7. Configure routing (LD 86, 87, 90) to send calls over SIP trunks.
8. Enjoy your SIP trunking.