Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SIP Trunk Dial Peers

Status
Not open for further replies.
MrNick0483

MrNick0483

IS-IT--Management
May 12, 2008
151
US
Currently my company has been given 2 SIP trunks (inbound & outbound) as a promo from a local cable service provider for us to do some testing and consideration of a switch from the PRI. We currently have CUCM-BE Ver. 7.1.5 and a 2811 VGWR cable of acting as a CUBE for the trunks. What I need some input on is how to configure the dial peers on the 2811 for inbound and outbound calling over the SIP trunks to the CUCM. From my understanding and talking with Cisco the CUCM will have a SIP trunk to the 2811 that will then have two dial peers for the CUCM to use, but after that I am stuck on the config.

Any input would be greatly appreciated.
 
Status
Not open for further replies.

Similar threads

Diya Freahat
  • Locked
  • Question
called name between avaya I P office & CUCM via SIP trunk
Replies
1
Views
241
Diya Freahat
Diya Freahat
Gnjiro
  • Locked
  • Question
Cisco Ip Phone 7841, 7821 Delay when making call both inbound and outbound in sip protocol
Replies
3
Views
423
thepfy
thepfy
Geordie12567
  • Locked
  • Question
Maximum concurrent calls on a SIP trunk with CUCM and Cube
Replies
2
Views
417
biglebowski
biglebowski
DTGMI
  • Locked
  • Question
Nortel to Cisco VG310 & 4431 SIP GWs
Replies
0
Views
131
DTGMI
DTGMI
Qzwsa
  • Locked
  • Question
Inband DTMF to SIP device for zone paging
Replies
1
Views
168
LoPath
LoPath

Part and Inventory Search

Sponsor

Back
Top