Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SIP Trunk Destination Address

Status
Not open for further replies.
Pete720

Pete720

IS-IT--Management
Mar 29, 2014
17
US
Hi, I am using CUCM 8.6. I am trying to configure SIP trunk in Branch location. For destination address, what address should I put? Is it the Branch router address or PSTN/WAN router address or CUCM server address?

Thanks
 
Sort by date Sort by votes
It would be the IP address of your sip gateway. If you are using cube then it would be the address of your cube. If you are terminating directly to cucm it would be the IP address of the sip device you need to connect to.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Diya Freahat
  • Locked
  • Question
called name between avaya I P office & CUCM via SIP trunk
Replies
1
Views
171
Diya Freahat
Diya Freahat
Gnjiro
  • Question
Cisco Ip Phone 7841, 7821 Delay when making call both inbound and outbound in sip protocol
Replies
3
Views
267
thepfy
thepfy
Geordie12567
  • Locked
  • Question
Maximum concurrent calls on a SIP trunk with CUCM and Cube
Replies
2
Views
277
biglebowski
biglebowski
DTGMI
  • Locked
  • Question
Nortel to Cisco VG310 & 4431 SIP GWs
Replies
0
Views
83
DTGMI
DTGMI
Qzwsa
  • Locked
  • Question
Inband DTMF to SIP device for zone paging
Replies
1
Views
116
LoPath
LoPath

Part and Inventory Search

Sponsor

Back
Top