SIP/ Netgear firewall

[HELPATECH]

i have upgraded from 4.2.27 to 5.0
i changed my d-link firewall (working fine)for a netgear Prosafe firewall FVS 338 because wanted to test (VPN phones no luck followed tech tips)
However when i changed it to netgear my SIP registration didnt register again when i did a reboot it register than for about 5mins cant make incoming calls only
i have the same settings i did on the d-link

is there something else i need to open on the netgear that i am not aware of any help thanks

 

[tlpeter]

For the sip i don't know
For the vpn phones, try set the phase 2 to any instead of what the docs say

ACS - Implement IP Office
ACA - Implement IP Telephony -- ACA - Design IP Telephony
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!

 

[Bas1234]

Start tracing then.

Put a hub between the POE injector from the VPN phone and start tracing with Wireshark, than on the IPO side between the router and the network.

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________