Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Simultaneous Paging on IPO R 9.0.20 build 860

Status
Not open for further replies.

ic1ssbill

Technical User
Feb 20, 2004
48
US
I have a customer that is replacing their Partner system with an IP Office (not muppet mode)> They were accustomed to using
Simultaneous paging . Is there a way to accomplish this in the IP Office ?. The customer has 15 IP phones and an analog trunk for the paging
 
You can only simultaneously page phones and overhead if it's connected to an analog station port.

-Austin
ACE: Implement IP Office
qrcode.png
 
What were they using for a paging amp on the Partner? You may need to add a Bogen UTI-1 paging interface.
 
WMT1A would be a better choice and set the analog to paging speaker. This can be added to a 'page'group and do simultaneous pages.

Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'
 
I used to use Valcom V9940's & Bogen UTI-1 to make paging work on just horns. But it was hit & miss on simultaneous paging. So what I have done is take an 6p6c screw terminal biscuit, put an 620 ohm resistor between Tip/Ring, Attach your lead wire to the same contact to the T/R of your speaker. This has worked for me without fail. setup the analog extension as a paging speaker, You can then add the analog extension to the paging hunt group and it will page them all
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top