bristolxyz
MIS
I have a cisco 1841. Currently I have a network configured as 10.20.36.xxx . I would like to add another range of addresses to be used (I am running out of hosts) as 10.20.37.XXX . I would like all network traffic to travel freely across these subnets. Pretty simple, but what would be the most effective way to configure it so i will not have too much trouble in the future?
Warm regards,
Bris
CTO
MSCE, CCNA, Novell, Symantec SS, Helicopter Pilot
Don't let what you can't do stand in the way of what you can
Warm regards,
Bris
CTO
MSCE, CCNA, Novell, Symantec SS, Helicopter Pilot
Don't let what you can't do stand in the way of what you can