Signaling Server - Load Balance

[cevamisto]

Hi ,

I have 2 Signaling Servers one is Leader with version sse-2.10.81 and one is Backup Follower with version sse-2.11.3.

When I want to see the telephones register to backup signaling server I have this message "Line TPS has not been initialized" but the "Enable Set TPS" is check in Node ID on signaling server backup configuration.

Who can I enable the TPS Line on backup Singnaling Server?
Where I can find load balance on Element Manager because I want to register the telephones on both Signaling Servers.

Thanks for your help,
Mike

 

[phoney]

not sure about the first part of your message, but to perform a load balance, you need to telnet into one of the signalling servers (doesn't matter which one) and at the oam prompt type

loadBalance

After the load balance is completed, you should see an even number of sets registered to each sig server when you do the isetShow command on each of the sig servers.

 

[cevamisto]

Ok Thanks, I'll try to see if something it happens.

Thanks